onu设备华为修订.docx
- songyiduo3620个人认证 |
- 2021-04-15 发布|
- 366.71 KB|
- 7页
CKBOOD was revised in the early morning of December 17, 2020. CKBOOD was revised in the early morning of December 17, 2020.
ONU设备华为修订
新加交换机比较繁琐,涉及到上联设备OLT和BAS。需要做的数据也比较多,需要多次操作才能得心应手。虽然在CMD窗口也可以操作,但是用SecureCRT会更方便。 工具/原料
SecureCRT
BatchCmdGen 高级命令生成器 方法/步骤
1
首先要和现场施工人员确定新加设备属于哪个区域,判断这台设备接在哪个OLT下面,在OLT上使用display ont autofind all 查看待加设备。然后在OLT 选线路模板:display ont-lineprofile gpon all ,最后还需要知道ont的id和外层vlan,可以通过查看已有的数据来确定:display current-configuration port 0/2/6或者根据公司台账。
2
给交换机一个静态地址,在bas上可以查看已用地址:display static 然后根据台账找到已经用的子接口,来确定该设备子接口display cur int eth-trunk
3
说了这么多,总结加一台ONU设备,需要准备如下:
SN号 上连OLT端口号 设备内外层VLAN ont-id 静态ip 所属子接口
4
接下来就是无脑模板啦
第一步:TCONT绑定DBA模板,再增加gemport与TCONT绑定
ont-lineprofile gpon profile-id %d profile-name 0/13/5_ONU-%d
tcont 1 dba-profile-id 3
gem add 0 eth tcont 1
gem add 1 e