面齿轮设计案例解析.pdf

想预览更多内容,点击预览全文

申明敬告:

本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己完全接受本站规则且自行承担所有风险,本站不退款、不进行额外附加服务;如果您已付费下载过本站文档,您可以点击这里二次下载

文档介绍

塑料面齿轮计算案例 目录 1 案例数据3 2 修改建议Modified Suggestion 3 2.1 ABOUT THE PINION 小齿轮部分3 2.2 ABOUT THE FACE GEAR 面齿轮部分5 3 软件界面输入5 4 软件输出报告6

15.10.2013 2 / 15 1 案例数据 2 修改建议Modified Suggestion

2.1 ABOUT THE PINION 小齿轮部分

15.10.2013 3 / 15 - To get the correct root diameter df and tip diameter da, you need to consider the profile shift of x*=0.2 on the pinion. - 为了得到确切的齿根圆直径df 和齿顶圆直径da ,需要考虑调整变位系数为0.2 ; - Change the tip diameter tolerance of the pinion. - 改变小齿轮上的齿顶圆公差; - To get the correct tooth thickness M on the pinion, you need to change the tooth thickness tolerances like this: - 为获得确切的小齿轮上的齿厚,需要改动齿厚公差为如下所示: - In the tab “Tolerances”, adjust the data as per the drawing (for the pinion): - 在“公差”内,对于小齿轮可以按照图纸上的要求改动为球直径0.35mm ; - Then, you can check in the KISSsoft report the data for the pinion - 之后根据KI

最近下载